Application Instructions

IMPORTANT! READ THIS SECTION IMMEDIATELY -- YOUR WARRANTY REQUIRES IT!

7. With your other hand, begin squeegeeing at the at the top and center of the part (Fig. 5).

Squeegee halfway down. With successive overlapping strokes, work outward until the entire top half of the part is applied. IMPORTANT: apply firm, even pressure with each stroke to prevent bubbling and wrinkling.

8. Remove the liner completely and repeat step 7 to apply the bottom half of the decal.

9. Wrap each end of this stripe section around the edge of the body panel. If the decal appears too long, trim its length first so that 3/8" extends beyond the edge of the panel.

10. Make any necessary trims around door handles, gas caps, etc. 11. Remove the translucent top layer (premask) by slowly and smoothly pulling it back upon itself (Fig.6).

As you pull it, your hands should be touching the car.

12. Apply the remaining positioned parts in similar fashion, visually checking for straightness as you proceed.

13. Position the stripe parts on the other side to the car and apply in the same fashion.

14. Position all lettering parts (legends). Hinge parts long their top edge with masking tape. Apply in same manner as striping. Long legends can be cut into shorter, more manageable pieces if necessary.