Application Instructions

IMPORTANT! READ THIS SECTION IMMEDIATELY -- YOUR WARRANTY REQUIRES IT!

Part III - After Application

1. DO NOT hand wash the for 3 days to allow time for the adhesive to cure. DO NOT machine or spray wash the car for 7 days after application.

2. DO NOT wax the surface of the graphics.

3. DO follow the cleaning instructions below, excerpted from 3M Technical Bulletins. Failure to follow them will void your warranty.

Part IV - Washing the Graphics

1. Use a cleaner which is non-abrasive, neither strongly acidic or alkaline, and is free of alcohol or solvents.

2. Flush the graphic's surface with clean water to remove loose dirt particles.

3. Wash the marking with a rag or sponge using a detergent which complies with Step 1. Avoid abrading the surface by unnecessary scrubbing. Once suds have been applied, rinse with a steady stream of water.

4. If using a pressure washer, the nozzle must be at least 12" away from and perpendicular to the marking. Pressure must not exceed 1500 psi and water temperature must not exceed 180 degrees F. Do Not direct the water stream at the edge of the marking or edge-lifting will occur.

5. Use of automatic car washes with rotating brushes is not advised unless the brushes are cloth. NYLON BRUSHES WILL DAMAGE THE GRAPHICS.

6. If tar, oil, diesel smut or bituminous material remains, wipe with a rag dampened with kerosene, mineral spirits, heptane or VM&P Naptha. Do not other solvents. Wash again with detergent and water. Rinse with clean water.

Back to Part 3